Buying guides, material comparisons and notes from our production floor in Dongguan. Written for engineers, sourcing managers and distributors who need to specify adhesive tape correctly the first time.
When engineering wire harnesses and electrical joints, choosing between heat shrink sleeves and pressure-sensitive tape impacts vibration tolerance, strain relief, and sealing. Here is the technical comparison.
Read article »As Europe's Design for Recycling framework takes shape under PPWR, industrial buyers must balance box sealing strength with repulpability. Here is what to specify.
Read article »Europe is shifting tape compliance from 'does it comply' to 'can you prove it'. Here is what the evidence chain looks like - and six questions worth sending any supplier.
Read article »A single temperature figure on a datasheet hides the three numbers that usually decide whether a tape survives your process. Here is what to ask for instead of a headline rating.
Read article »Silicone and acrylic adhesives are not interchangeable above 150°C. A four-point comparison of temperature, initial tack, holding power and cost, and the failure each one causes when it is the wrong choice.
Read article »Residue on gold fingers after reflow is usually a temperature, dwell-time or removal-angle problem rather than a bad roll of tape. Three causes, and a self-check list to run before the next batch.
Read article »Harness tape is chosen by where the loom runs, not by what is already in the stores. A practical look at temperature zoning, full versus partial wrap, and what to confirm with your customer.
Read article »Copper foil and conductive fabric tape both shield, but they are chosen for different geometry. Four points of comparison, plus how adhesive choice and die-cutting change the assembly.
Read article »Floor tape in an electronics plant does two different jobs: dividing protected areas and warning about hazards. Choosing one product for both is where most layouts go wrong.
Read article »Custom width is the most common request we get and the one most often quoted wrongly, because the enquiry is missing the four numbers a factory needs. Here is what to send.
Read article »An appliance line uses several tapes at several stations, and each station has its own temperature and removal requirement. A station-by-station look at how the list is built.
Read article »MOQ and lead time are the two answers that decide whether an order is workable, and both depend on what you tell the factory. The seven points to confirm in writing before you commit.
Read article »Tape, silicone plugs and masking film all keep powder off a surface, and each one wins on a different geometry. How to choose per feature rather than per part.
Read article »Peak temperature is only the first question. Backing, adhesive system and the surface you are bonding to decide whether a tape survives the process or fails in it.
Read article »Why polyimide tape is the default choice for masking gold fingers and SMT reflow, where it is used, and how to specify thickness and width correctly.
Read article »PTFE coated fiberglass tape is chosen for release and chemical resistance rather than grip. The applications where that trade pays off, and where it does not.
Read article »Green PET silicone masking tape is the workhorse of powder coating and plating. Why green, what the silicone adhesive does, and how to order custom widths.
Read article »What to prepare before ordering printed packing tape, how the print repeats across the roll, and the practical limits that affect artwork and cost.
Read article »Flannel cloth tape is specified for wire harness wrapping where noise, abrasion and heat all matter. How to choose between a full and partial wrap.
Read article »Glass cloth tape is chosen where the tape has to hold under load at temperature. What the woven backing adds, and how it differs from a film tape.
Read article »Three backings that are often quoted interchangeably for the same job, and the practical differences that decide which one belongs on your line.
Read article »
